# Linux version 2.4.19-m32r (sakugawa@pcmp02) (gcc version 3.2.3 m32r-20030523) #103 SMP Thu Jan 8 14:45:06 JST 2004 initrd:start[882a0000]:end[88889ac0],size[005e9ac0] On node 0 totalpages: 16383 zone(0): 16383 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: console=tty1 console=ttyD0,115200n8x root=/dev/sda1 ip=192.168.0.102:192.168.0.1::255.255.255.0:mappi002::off; Initializing CPU#0 Timer start:Interval = 781 Console: colour dummy device 80x25 Calibrating delay loop... 9.70 BogoMIPS Memory: 56848k/65532k available (1231k kernel code, 8684k reserved, 230k data, 116k init) Dentry cache hash table entries: 8192 (order: 4, 65536 bytes) Inode cache hash table entries: 4096 (order: 3, 32768 bytes) Mount-cache hash table entries: 1024 (order: 1, 8192 bytes) Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes) Page-cache hash table entries: 16384 (order: 4, 65536 bytes) POSIX conformance testing by UNIFIX M32R-mp information On-chip CPUs : 4 CPU model : M32R-XNUX2MP/Mappi-II(Ver.1.01) CPU0: CPU clock 10.00MHz, Bus clock 10.00MHz, loops_per_jiffy[48512] CPU present map: f Booting processor 1/1 Waiting for send to finish... Initializing CPU#1 CPU#1 (phys ID: 1) waiting for CALLOUT +After Startup. Before Callout 1. After Callout 1. Calibrating delay loop... 9.77 BogoMIPS Stack at about 8888d3ec OK. CPU1: CPU clock 10.00MHz, Bus clock 10.00MHz, loops_per_jiffy[48896] CPU has booted. Booting processor 2/2 Waiting for send to finish... Initializing CPU#2 CPU#2 (phys ID: 2) waiting for CALLOUT +After Startup. Before Callout 2. After Callout 2. Calibrating delay loop... 9.90 BogoMIPS Stack at about 8829f3ec OK. CPU2: CPU clock 10.00MHz, Bus clock 10.00MHz, loops_per_jiffy[49536] CPU has booted. Booting processor 3/3 Waiting for send to finish... Initializing CPU#3 CPU#3 (phys ID: 3) waiting for CALLOUT +After Startup. Before Callout 3. After Callout 3. Calibrating delay loop... 9.88 BogoMIPS Stack at about 8829d3ec OK. CPU3: CPU clock 10.00MHz, Bus clock 10.00MHz, loops_per_jiffy[49408] CPU has booted. Before bogomips. Total of 4 processors activated (39.27 BogoMIPS). Before bogocount - setting activated=1. Boot done. Setting commenced=1, go go go Waiting on wait_init_idle (map = 0xe) All processors have done init_idle Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd devfs: v1.12a (20020514) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 Console: switching to colour frame buffer device 80x30 fb0: Chips 65545 frame buffer (1024K RAM detected) pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with no serial options enabled SMSC LAN91C111 Driver (v2.0), (Linux Kernel 2.4 + Support for Odd Byte) 09/24/01 - by Pramod Bhardwaj (pramod.bhardwaj@smsc.com) eth0: SMC91C11xFD(rev:1) at 0x300 IRQ:1 MEMSIZE:8192b NOWAIT:0 ADDR: 08:00:70:25:66:1f RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize loop: loaded (max 8 devices) SCSI subsystem driver Revision: 1.00 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2 Linux Kernel Card Services 3.1.22 options: none usb.c: registered new driver usbdevfs usb.c: registered new driver hub mice: PS/2 mouse device common for all mice ttyD0 initialized. ttyD1 initialized. devfs_register(ttyD): could not append to parent, err: -17 m32r_cfc.c 0.002 2003/05/22 12:10:24 (Hiroyuki Kondo) m32r_cfc pcc at 0x00000000 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 4096 bind 4096) eth0: PHY=LAN83C183 (LAN91C111 Internal) IP-Config: Complete: device=eth0, addr=192.168.0.102, mask=255.255.255.0, gw=255.255.255.255, host=mappi002, domain=, nis-domain=(none), bootserver=192.168.0.1, rootserver=192.168.0.1, rootpath= NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. cs: socket 8bf9d800 timed out during reset. Try increasing setup_delay. RAMDISK: ext2 filesystem found at block 0 RAMDISK: Loading 4000 blocks [1 disk] into ram disk... done. Freeing initrd memory: 6054k freed VFS: Mounted root (ext2 filesystem). Mounted devfs on /dev serial console detected. Disabling virtual terminals. init started: BusyBox v0.60.3-pre (2004.01.07-15:36+0000) multi-call binary mount: Mounting /dev/ram0 on / failed: No such file or directory BusyBox v0.60.3-pre (2004.01.07-15:36+0000) Built-in shell (msh) Enter 'help' for a list of built-in commands. # ls bin etc initrd linuxrc proc usr dev home lib lost+found sbin # cat /proc/interrupts CPU0 CPU1 CPU2 CPU3 1: 0 0 2 0 MAPPI2-IRQ eth0 18: 660 1669 2403 1183 MAPPI2-IRQ timer 41: 0 0 0 0 MAPPI2-IRQ m32r_cfc 42: 0 0 0 0 MAPPI2-IRQ m32r_cfc 48: 12 13 26 26 MAPPI2-IRQ serial_rx 49: 2 37 93 73 MAPPI2-IRQ serial_tx NMI: 0 0 0 0 ERR: 0